50 - 4000m3 / H Automatic Self Cleaning Filter For Metal Processing Plants

Automatic Self Cleaning Filter Working principle
Filtering state: Liquid from the efficient backwash filter inlet injection, from up to down flow, through the filter element surface to flow outlet; When the filter element surface collect to a certain impurities, fixed time or set pressure tp started cleaning procedures.
Cleaning state: cylinder drive wash plate to straight action, this part of the impurities with the descending liquid through washing dish to fall into the collection chamber, to repeat washing several times to clean the filter element.
The most important part of the filters, that provides quite simple and reliable cleaning process, is a disk which is installed on pneumatic cylinder. When a disk, placed on pneumatic cylinder's end, passes between water and filter basket, filter basket is cleaned with this movement of the disk. Flow speed of the water increases on the points around the disk and static pressure decreases pursuant to Bernoulli principle
Low static pressure creates vacuum effect on edge points of the disk and contaminants are discharged from the drainage line by being cleaned from the filter basket.

Automatic Self Cleaning Filter material

■Shell: carbon steel, 304 stainless steel, 316L stainless steel
■Screen: 304 stainless steel, 316L stainless steel
■Brush holder: 304 stainless steel, 316L stainless steel
■Drain valve, cast iron,copper,stainless steel,PVC,nylon
■Controller: PVC, aluminum
■Seal ring: EPDM rubber
■Cleaning brush: stainless steel, nylon

Automatic Self Cleaning Filter structure

Automatic Self Cleaning Filter Technical parameters
■Wide filtration range:screens from 4000 to 20 microns
■Working pressure(min)≥0.18Mpa
■Working pressure(max)≤1.6MPa(customized is available)
■Working temperature ≤65℃
■Power supply: 380 v / 50 Hz (Customized is availabel)
■Cleaning method: brush type
■Adjustable cleaning time: 10-200 seconds

Automatic Self Cleaning Filter specification table